Selection Criteria for Check Valves

Sep 07, 2026 Leave a message

1. Check valves should be installed on equipment, installations, and pipelines to prevent backflow of the medium;
2. Check valves are generally suitable for clean media and are not recommended for media containing solid particles or those with high viscosity;
3. Horizontal lift check valves should generally be selected for horizontal pipelines with a nominal diameter of 50mm;
4. Straight-through lift check valves can only be installed on horizontal pipelines;
5. For water pump inlet piping, a foot valve is recommended; foot valves are typically installed only on vertical inlet pipes where the medium flows from bottom to top;
6. Lift check valves offer better sealing performance than swing check valves but have higher fluid resistance; horizontal types should be installed on horizontal pipelines, while vertical types are installed on vertical pipelines;
7. The installation position of swing check valves is not restricted; they can be installed on horizontal, vertical, or inclined pipelines. If installed on a vertical pipeline, the medium must flow from bottom to top;
8. Swing check valves are not typically manufactured in small diameters but can be designed for very high working pressures (nominal pressure up to 42 MPa) and very large nominal diameters (exceeding 2000 mm). Depending on the materials used for the body and seals, they are suitable for a wide range of working media and temperatures, including water, steam, gases, corrosive media, oils, and chemicals. The operating temperature range for the medium is between -196°C and 800°C;
9. Swing check valves are suitable for low-pressure, large-diameter applications, though installation locations are restricted;
10. Butterfly check valves are not restricted by installation position; they can be installed on horizontal, vertical, or inclined pipelines;
11. Diaphragm check valves are suitable for pipelines prone to water hammer; the diaphragm effectively eliminates water hammer caused by backflow. They are generally used in low-pressure, ambient-temperature pipelines-particularly in municipal water supply lines-with an operating temperature range of -12°C to 120°C and a working pressure of less than 1.6 MPa; however, they can be manufactured in very large sizes, with a maximum nominal diameter (DN) exceeding 2000 mm;

Send Inquiry

Send Inquiry