When a gate valve closes, the sealing surfaces can rely solely on the pressure of the medium to achieve a seal-meaning the medium's pressure forces the gate's sealing surface against the seat on the opposite side; this is known as self-sealing. However, most gate valves employ forced sealing, where external force is required to press the gate against the seat upon closure to ensure a tight seal.
Movement mechanism: In this type of gate valve, the gate moves linearly along with the stem; these are also known as rising-stem gate valves. Typically, the rising stem features trapezoidal threads; a nut at the top of the valve and guide grooves on the valve body convert rotational motion into linear motion-transforming operating torque into operating thrust. When opening the valve, the fluid passage becomes fully unobstructed once the gate has been lifted to a height equal to the valve's bore diameter; however, this specific position cannot be visually monitored during operation. In practice, the fully open position is determined by the stem's highest point-specifically, the limit of its upward travel. To prevent binding caused by thermal expansion, the valve is usually backed off by half a turn to a full turn from the maximum open position to establish the final fully open setting. Thus, the fully open position is defined by the gate's location (i.e., its travel). In some gate valves, the stem nut is located on the gate itself; turning the handwheel rotates the stem, thereby lifting the gate. These are known as rotating-stem or non-rising-stem gate valves.
